Simple Operation for monitor PH value (Low or High PH will cause the aquarium make disease)
Durable and Reliable
Ideal For Salt Water and Fresh Water
The controler can power on the CO2(Not included)or calcium reactor(Not included) to control the PH value
Specification
Measurement- 0~14pH
Resolution- 0.01pH
Accuracy- 0.01pH
Power for 220V to 240V 50/60Hz
Include PH Pen , calibration
Operation:
Connect the AC power (230V~50/60Hz).
Connect the PH electrode to PH terminal.
Put the PH electrode into the buffer solution with the standard PH7. Adjust the knob "CAL/PH7" with the plastic screwdriver until the display reads "7.00".
Put the PH electrode int the water after calibration and start to work.
Normally, the best PH for plant aquarium is PH6.8~PH7.2 and for the seawater aquarium is PH8.0~8.4.
Connect the CO2 system(Not included) to the controller and it will lower the PH with the CO2 system.
Easy and simple to setup, calibration abit sensative but that's nothing to sneeze about.
00
CommentLikeDislike
KOKKINIS on29 Okt 2009, 2:12 PM
Nice!
It's a very good ph controller & very cheap for the work that offers!
The calibration is a lit bit difficult!
00
CommentLikeDislike
Ciubotariu on9 Okt 2009, 11:04 AM
positive
It works, it is cheap. The smallest price on the market. It looks good. It will be better with a smaller hysteresis. Maybe the producer will change this in the future. It is +/- 0.1.
The Ph probe is good. It was well packed.
It is incredible how cheap it is with included PH-probe and calibration solution.
